Homepage
The RCJ15 flush-mounted receiver for heating control regulates a connected heating unit based on the switching signals received from an Easywave temperature sensor ST01.

In doing so, the RCJ15 determines by itself whether adjustment is needed either via the ON/OFF mode or via pulse-width modulation (PWM).

In addition, up to 16 window contacts *) (OFF/ON) can be programmed into the receiver in order to stop the heating automatically when a window is opened.

If the radio connection to the thermostat is interrupted, the RCJ15 goes into emergency mode after 10 hours, thus preventing the room from cooling down.

RCJ15E5001-01-23K
Technical specifications
Coding Easywave
1x ST01 and maximum 16x RTS16 or RTS26 *) can be programmed.
Frequency 868,30 MHz
Channels 1
Power supply 230 V AC, 50 Hz
Power consumption 0,2 W standby
0,7 W relay switched (without load)
Operating modes temperature control
PWM
ON/OFF
Outputs 1 relay contact (normally open)
Maximum contact load 10.0 A / 2.300 VA
Operating temperature -20 °C to +60 °C
Dimensions 48 x 48 x 25 mm
*) The following window contacts are compatible:
RTS16E5001B02 OFF/ON
RTS16E5001-02 STATUS, OFF/ON
RTS16E5001A02 STATUS, OFF/ON
RTS26E5001B03 OFF/ON
RTS26E5001A03 STATUS, OFF/ON
Scope of delivery
  • Flush-mounted receiver
  • Operating manual
Models
Product numbers Description
RCJ15E5001-01-23K Flush-mounted receiver, Easywave, 230V, 1x normally open, pot.-loaded, heating control PWM/ON/OFF
Wiring diagram