RCJ33 Flush-mounted receiver pulse output (5 seconds)
The RCJ33 flush-mounted receiver receives transmission codes from up to 200 programmed secwave radio transmitters and triggers
a 5-second pulse on the connected device via a pulse output (changeover).
This enables, for example, the safe control of a door buzzer via radio. In addition, a button input is available so that the pulse can also be triggered via wire by a key switch.
The flat design facilitates installation in flush-mounted sockets, behind switches or behind sockets.
This enables, for example, the safe control of a door buzzer via radio. In addition, a button input is available so that the pulse can also be triggered via wire by a key switch.
The flat design facilitates installation in flush-mounted sockets, behind switches or behind sockets.
RCJ33S5001A01
Technical specifications
| Coding | secwave, AES 128-bit encryption Up to 200 transmitters can be programmed. Not compatible with Easywave products! |
| Frequency | 868,30 MHz |
| Channels | 1 |
| Power supply | 12-24 V AC/DC |
| Power consumption
(at 24V AC) | 0.2 W standby 1.0 W relay switched (without load) |
| Operating mode | PULSE (5 seconds) |
| Input | 1 external button |
| Output | 1 potential-free relay contact (changeover) |
| Maximum contact load | AC: 60V / 1A / 60VA DC: 30V / 1A / 30VA |
| Operating temperature | -20 °C to +45 °C |
| Dimensions | 43 x 42 x 17,5 mm |
Scope of delivery
- Flush-mounted receiver, pulse output (5s)
- Operating manual
Models
| Product numbers | Description |
|---|---|
| RCJ33S5001A01 | Flush-mounted receiver, secwave, 12-24V, 1x pulse output (5s), potential-free, button input |
Wiring diagram
